• Thanks: 3

Re: New RIFE filter - 3x faster AI interpolation possible in SVP!!!

dawkinscm wrote:
AutumQueen92 wrote:
osudahiuhsdfg wrote:

Can someone confirm if with RIFE I should be using DXVA2, DXVA2 copyback, or D3D11? RTX 5080 and struggling with DXVA2 copyback for some reason.


I used D3D11 since some .mkv won't play without it.
Did you enable GPU acceleration? Not using it was one of the main reason i get frame drops.
Also had to use SVP to downscale 1080p > 720p otherwise it stutters more on my 4060ti

Edit: I was interpolating to 120hz, so the downscale wouldn't have been necessary. No regrets anyway, I see no difference. Nvidia super resolution will upscale it in fullscreen

Although I made a mistake. Rhe original question suggests you may end up being on long term support explaining the very basics until a lot more reading has been done by the OP.


I don't need your condescending and unhelpful tripe anywhere near my posts.

2,552 Reply by dawkinscm (edited by dawkinscm 16-03-2026 23:53:32)

  • Thanks: 266
  • Thanks for the post: 1

Re: New RIFE filter - 3x faster AI interpolation possible in SVP!!!

AutumQueen92 wrote:
dawkinscm wrote:
AutumQueen92 wrote:

I used D3D11 since some .mkv won't play without it.
Did you enable GPU acceleration? Not using it was one of the main reason i get frame drops.
Also had to use SVP to downscale 1080p > 720p otherwise it stutters more on my 4060ti

Edit: I was interpolating to 120hz, so the downscale wouldn't have been necessary. No regrets anyway, I see no difference. Nvidia super resolution will upscale it in fullscreen

Although I made a mistake. Rhe original question suggests you may end up being on long term support explaining the very basics until a lot more reading has been done by the OP.


I don't need your condescending and unhelpful tripe anywhere near my posts.

Oh you again. Serves me right for not checking. A mistake I won't make again. Holding up a mirror then projecting is a new trick for you but I haven't seen too many of your posts. Looks like I wasn't missing much.

By the way. Don't use big words unless you know what they mean and how to use them. <--- See that right there? That is "condescending". Carry on!

  • Thanks: 3

Re: New RIFE filter - 3x faster AI interpolation possible in SVP!!!

Because of my performance difficulties that I CANNOT FIGURE OUT, which is driving me nuts, I will need to pick between madVR HDR (vs. an alternative) or SVP RIFE (vs. SVP standard). How noticeable is the improvement of RIFE over the standard algorithm? Is it discernable in a blind test?

2,554 Reply by dawkinscm (edited by dawkinscm 26-03-2026 21:18:35)

Re: New RIFE filter - 3x faster AI interpolation possible in SVP!!!

osudahiuhsdfg wrote:

Because of my performance difficulties that I CANNOT FIGURE OUT, which is driving me nuts, I will need to pick between madVR HDR (vs. an alternative) or SVP RIFE (vs. SVP standard). How noticeable is the improvement of RIFE over the standard algorithm? Is it discernable in a blind test?

The answer is it depends. Rife makes it easier to produce better looking results. Turn on RIFE, load the engine -> get a decent result. So technically it might be better than "a" standard algorithm. But  unless you are mainly watching Anime which is what it is designed for, it produces way too many artifacts for live content. SVP (with work and testing) can produce the same results, especially at  high frame rates like 120Hz and above. But without the large number of artifacts. Right now, from all my movies, I have maybe 2 artifacts that can only be seen on a very large screen. With RIFE I had that many artifacts or more, "per movie" that can be seen on almost any size screen.

  • Thanks: 3

Re: New RIFE filter - 3x faster AI interpolation possible in SVP!!!

dawkinscm wrote:
osudahiuhsdfg wrote:

Because of my performance difficulties that I CANNOT FIGURE OUT, which is driving me nuts, I will need to pick between madVR HDR (vs. an alternative) or SVP RIFE (vs. SVP standard). How noticeable is the improvement of RIFE over the standard algorithm? Is it discernable in a blind test?

The answer is it depends. Rife makes it easier to produce better looking results. Turn on RIFE, load the engine -> get a decent result. So technically it might be better than "a" standard algorithm. But  unless you are mainly watching Anime which is what it is designed for, it produces way too many artifacts for live content. SVP (with work and testing) can produce the same results, especially at  high frame rates like 120Hz and above. But without the large number of artifacts. Right now, from all my movies, I have maybe 2 artifacts that can only be seen on a very large screen. With RIFE I had that many artifacts or more, "per movie" that can be seen on almost any size screen.

Yes I did find RIFE to have too many problems in movies for sure, so sticking to standard algorithm seems like a good call! Still pissed I can't get RIFE to work though. I hope it's a weird glitch and not a bad GPU problem.

Re: New RIFE filter - 3x faster AI interpolation possible in SVP!!!

osudahiuhsdfg wrote:
dawkinscm wrote:
osudahiuhsdfg wrote:

Because of my performance difficulties that I CANNOT FIGURE OUT, which is driving me nuts, I will need to pick between madVR HDR (vs. an alternative) or SVP RIFE (vs. SVP standard). How noticeable is the improvement of RIFE over the standard algorithm? Is it discernable in a blind test?

The answer is it depends. Rife makes it easier to produce better looking results. Turn on RIFE, load the engine -> get a decent result. So technically it might be better than "a" standard algorithm. But  unless you are mainly watching Anime which is what it is designed for, it produces way too many artifacts for live content. SVP (with work and testing) can produce the same results, especially at  high frame rates like 120Hz and above. But without the large number of artifacts. Right now, from all my movies, I have maybe 2 artifacts that can only be seen on a very large screen. With RIFE I had that many artifacts or more, "per movie" that can be seen on almost any size screen.

Yes I did find RIFE to have too many problems in movies for sure, so sticking to standard algorithm seems like a good call! Still pissed I can't get RIFE to work though. I hope it's a weird glitch and not a bad GPU problem.

SVP is better than RIFE so I wouldn't worry about it.