1 Topic by killin (edited by killin 09-09-2020 19:45:25)

Topic: Red line around video in mpc-hc

Did an install of SVP4 Pro last night, beforehand I removed all added settings, codecs, players, splitters, filters, ffdshow, vapoursynth, and leftovers I could find. I ran the installation as default as possible, following the https://www.svp-team.com/wiki/SVP:MPC-HC guide, the only thing I changed was adding Dolby/DTS to the built-in audio LAV decoder as I use a receiver. it's playing good enough for a default install, and Dolby/DTS is working. This is my only issue... https://imgur.com/a/Rkr37rt This red outline around the video output in mpc-hc, any suggestions would be greatly appreciated. Thanks!!!

Re: Red line around video in mpc-hc

This actually means it doesn't work. Please attach the full log here. Do you see the "SVP index" graph working on the Perf. graphs page?

Re: Red line around video in mpc-hc

Apologies, this was an error caused by my overactive antivirus software. I whitelisted the directory, rebooted and the issue went away, I have the fuzzy light bars again, and the 'svp index' showing 1.00. my cpu load is around 30% gpu 4.8% is there an easy way to push more work to the gpu, and ease the taxing on the cpu? Or maybe a different setup I could try, Thanks again!

Post's attachments

active.log 6.31 kb, 199 downloads since 2020-09-10 

Re: Red line around video in mpc-hc

30% cpu load is fine

> is there an easy way to push more work to the gpu

buy an RTX card big_smile

  • Thanks: 7

Re: Red line around video in mpc-hc

GTX 1660 also works.