Topic: SVPlight Frozen

I have a custom made ambilight setup. WS2812b LEDs connected to an Arduino Uno running fast led and using Prismatik software. With Prismatek it works fine. However I want to use SVPlight because of the better features. I install it and run it and set it up to use the Prismatik software. I can also see where it locks it down to use its API. I go to configure and test with SVPlight but nothing happens it wont change color or swirl or anything. It appears to not be sending any data to the LED's. Anyone have any ideas whats going on?

Re: SVPlight Frozen

How many leds?

Re: SVPlight Frozen

149 Leds

Re: SVPlight Frozen

Try 99  wink

5 (edited by 422415 12-04-2015 03:04:30)

Re: SVPlight Frozen

So I created a 99 led profile in Prismatik and imported it and changed the settings in SVPlight to 99. It now shows the correct colors but it doesn't swirl.

Re: SVPlight Frozen

Just remembered another issue - default serial port speed 115200 is too low for 60 hz updates. Increase it to 460800 (on both ends, in Arduino and in Prismatik).